Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual page 669

Configuring QoS
Example 1: Source Port Group
In the following example, a port group (pgroup) is created with two ports and attached to a policy condi-
tion (Ports). A policy action with maximum bandwidth is created (MaxBw). The policy condition and
policy action are combined in a policy rule called PortRule.
-> policy port group pgroup 1/1-2
-> policy condition Ports source port group pgroup
-> policy action MaxBw maximum bandwidth 10k
-> policy rule PortRule condition Ports action MaxBw
In this example, if both ports 1 and 2 are active ports, the 10000 bps maximum bandwidth is shared by
both ports. In other words, maximum bandwidth policies for port groups define a maximum bandwidth
value that is a total bandwidth amount for all ports, not an amount for each port.
Example 2: Destination Port Group
In the following example, a port group (pgroup2) is created with several ports and attached to a policy
condition (Ports2). A policy action with maximum bandwidth is created (MaxBw). The policy condition
and policy action are combined in a policy rule called PortRule2.
-> policy port group pgroup2 1/1 1/25 2/1
-> policy condition Ports2 destination port group pgroup2
-> policy action MaxBw maximum bandwidth 10k
-> policy rule PortRule2 condition Ports2 action MaxBw
In this example, the specified ports for pgroup2 span across two slots. As a result, the maximum band-
width limit specified by the policy action is increased to 20K for all of the ports. The bandwidth limit is
increased by multiplying the number of slots by the specified bandwidth value.
OmniSwitch 6800/6850/9000 Network Configuration Guide
Using Condition Groups in Policies
March 2008 page 30-49