Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual page 603

Using ACL Manager
Command
[sequence number] {permit | deny}
protocol
{source source-wildcard | host address | any}
[operator [port]]
{destination destination-wildcard |
host address | any}
[operator [port]]
[established]
[precedence precedence]
[tos tos]
[log | log-input]
[time-range time-range-name]
no [sequence number]
no deny protocol source source-wildcard
destination destination-wildcard
no permit
protocol
{source source-wildcard | host address | any}
[operator [port]]
{destination destination-wildcard |
host address | any}
[operator [port]]
[established]
[precedence precedence]
[tos tos]
[log | log-input]
[time-range time-range-name]
remark remark
end
exit
OmniSwitch 6800/6850/9000 Network Configuration Guide
Description
Creates an ACL entry for the active named extended
ACL. The optional sequence number parameter specifies
the number assigned to the entry. If a number is not spec-
ified with this command, the next available number is
used.
Repeat this command for each additional entry that you
want to add to the active named ACL.
Use the no forms of this command to remove the speci-
fied ACL entries.
Note: The operator and established parameters are only
used for TCP/UDP ACLs.
See "Supported Protocols and Services" on page 28-15
for a list of supported IP protocols and TCP/UDP service
types.
Examples:
permit ip any any
deny tcp ftp any any
no ip any any
Adds a comment to the active ACL. Enter up to 256
characters.
Examples:
remark ACL filters icmp traffic on any host.
Exits the Access List Configuration Mode and returns to
the Privileged Exec Mode.
Exits the Access List Configuration Mode and returns to
the Global Configuration Mode.
March 2008
ACLMAN Modes and Commands
page 28-13