Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual page 608

Hide thumbs Also See for OmniSwitch 6800 Series:

Table of Contents

Configuring ACLs

Aclman(config)#access-list 102 deny ip host 178.4.25.1 any

Aclman(config)#access-list 102 permit udp any any

Aclman(config)#access-list 102 deny udp host 178.4.25.1 any

To remove a numbered ACL, use the no form of the access-list command. Note that removing a single

entry from a standard ACL is not allowed without deleting the entire ACL. To avoid having to re-enter an

entire ACL each time a change is required, use one of the following configuration methods:

Create a named ACL instead of a numbered ACL. Removing individual ACL entries is allowed with-

out having to remove and re-enter the entire ACL. See

ACLs" on page 28-19

Create the numbered ACL configuration in a text file and use the Privileged Exec Mode import

command to load the text file syntax into the ACLMAN running configuration. Then each time a

change is required for this ACL, simply edit the text file and import the file contents into the

ACLMAN configuration. For more information about importing ACL text files, see

Text Files" on page

for more information.

OmniSwitch 6800/6850/9000 Network Configuration Guide

"Configuring Named Standard and Extended

Using ACL Manager

"Importing ACL