Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual page 684

Hide thumbs Also See for OmniSwitch 6800 Series:

Table of Contents

Policy Applications

For example:

In this scenario, traffic from the firewall is sent back to the switch to be re-routed. But because the traffic

re-enters the switch through a port that is not in the Slot01 port group, the traffic does not match the

Redirect_All policy and is routed normally through the switch.

-> policy condition Traffic3 source ip 10.3.0.0 mask 255.255.0.0 source port

group Slot01

-> policy action Firewall permanent gateway ip 173.5.1.254

-> policy rule Redirect_All condition Traffic3 action Firewall

Make sure to enter the qos apply command to activate the policy rule on the switch. Otherwise the rule

will be saved as part of the pending configuration, but will not be active.

Using a Built-In Port Group

OmniSwitch 6800/6850/9000 Network Configuration Guide

Configuring QoS