Enabling And Disabling The Mld Spoofing; Enabling The Mld Spoofing; Enabling And Disabling The Mld Zapping - Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual

Hide thumbs Also See for OmniSwitch 6800 Series:

Table of Contents

Configuring IP Multicast Switching

Or, as an alternative, enter:

-> ipv6 multicast vlan 2 robustness

To restore the MLD robustness to its default value.

Enabling and Disabling the MLD Spoofing

By default, MLD spoofing (i.e., replacing a client's MAC and IPv6 address with the system's MAC and

IPv6 address, when proxying aggregated MLD group membership information) is disabled on the switch.

The following subsections describe how to enable and disable spoofing by using the

To enable MLD spoofing on the system if no VLAN is specified, you use the

command as shown below:

-> ipv6 multicast spoofing enable

You can also enable MLD spoofing on the specified VLAN by entering:

-> ipv6 multicast vlan 2 spoofing enable

Disabling the MLD Spoofing

To disable MLD spoofing on the system if no VLAN is specified, you use the

command as shown below:

-> ipv6 multicast spoofing disable

Or, as an alternative, enter:

-> ipv6 multicast spoofing

To restore the MLD spoofing to its default setting (i.e., disabled).

You can also disable MLD spoofing on the specified VLAN by entering:

-> ipv6 multicast vlan 2 spoofing disable

Or, as an alternative, enter:

-> ipv6 multicast vlan 2 spoofing

To restore the MLD spoofing to its default setting (i.e., disabled).

You can remove an MLD spoofing entry on the specified VLAN and return to its default behavior by

-> no ipv6 multicast vlan 2 spoofing

By default MLD (i.e., processing membership and source filter removals immediately without waiting for

the protocol's specified time period – this mode facilitates IP TV applications looking for quick changes

OmniSwitch 6800/6850/9000 Network Configuration Guide

Modifying IPMSv6 Parameters

ipv6 multicast spoofing

ipv6 multicast