Diagnosing Switch Problems
Enter the following QoS commands to override source learning:
-> policy condition c_is1 source vlan 1000
-> policy action a_is1 redirect port 2/2
-> policy rule r_is1 condition c_is1 action a_is1
-> qos apply
Note. If the intermediate switches are not OmniSwitches, refer to the vendor's documentation for instruc-
tions on disabling or overriding source learning.
Configuring Destination Switch
Follow the steps given below to configure the Destination Switch:
-> vlan 1000
-> vlan 1000 stp disable
-> vlan 1000 802.1q 3/1
-> vlan 1000 port default 3/2
Enter the following QoS commands to override source learning:
-> policy condition c_ds1 source vlan 1000
-> policy action a_ds1 redirect port 3/2
-> policy rule r_ds1 condition c_ds1 action a_ds1
-> qos apply
OmniSwitch 6800/6850/9000 Network Configuration Guide
March 2008
Application Example
page 35-19