Lanier Copier System Edition Operating Instructions Manual page 57

Clearing and Adjusting the Machine
A If you have adjusted the color
calibration in copy mode, the
following display appears.
Press [Start Printing].
2
B If you have adjusted the color
calibration in printer mode, the
following display appears. Se-
lect [600 x 600 dpi], [1200 x 600
dpi], or [1200 x 1200 dpi] as the
resolution for color calibration,
and then press [Start Printing].
The test pattern will be printed.
Note
❒ Immediately after selecting
[Start Printing] from this
menu, a self-check starts.
Wait a few minutes for the
test pattern to be printed.
Important
❒ If the toner has almost run
out, the message "Test Pat-
tern could not be printed.
Print it again." appears on the
control panel and the ma-
chine does not carry out
A u t o C o l o r C al ib r at i o n .
Make sure there is sufficient
toner for Auto Color Calibra-
tion. If there is not, replace
the cartridge. See p.4 "Re-
p l a c i n g t h e T o n e r C a r -
tridge".
46
F F F F
Place the printed arrow of the test
pattern sheet at the left corner of
the exposure glass with the print-
ed side down.
G G G G
Press [Start Scanning].
Adjustment of the color calibration
starts.
Note
❒ If the sheet is not loaded proper-
ly, the following message ap-
pears.
H H H H
When all the settings have been
made, press the { { { { User Tools/Counter} } } }
key.
The initial display is shown.