Lanier Copier System Edition Operating Instructions Manual page 125

Messages
Photoconductor Units Setting Error
Photoconductor Units are not set
properly: Black, Yellow, Magenta,
Cyan
Open the part as shown and set the
unit.
Problem with the hard disk.
Call service.
Problem with IEEE 1394 board.
Call service.
Problem with the printer module.
Call service.
Punch has been cancelled.
Operating Instructions
Description
The indicated Photoconductor
Unit(s) is/ are not set correctly, or is
not set.
The printer identified a hard disk
drive error.
The printer identified an IEEE1394
Board error.
The printer identified a DIMM sum
value error.
The setting of punch function has
been cancelled.
Maintenance Guide 2 Copier System Edition
Set the indicated Photoconductor
Unit(s) correctly.
See "Replacing Consumables and
Maintenance Kit" in Maintenance
Guide 1.
Turn the main power switch off and
then on. If the message appears again,
contact your sales or service repre-
sentative.
Reference
Before turning the main pow-
er switch, see "Turning Off
the Main Power" in Adminis-
trator Reference 1.
Contact your sales or service repre-
sentative.
Contact yoursales or service repre-
sentative.
Verify that the paper orientation, pa-
per feed direction and the setting of
punch where you desire.
Solution
54