Lanier Copier System Edition Operating Instructions Manual page 122

Messages
LCT has a problem. Turn Main Pow-
er Switch off then on. If the error ap-
pears again, call service
representative.
Load following paper in Tray #, or
select another tray and press [Contin-
ue].
To cancel job, press [Reset].
Required:<xxx> <yyy>
NV-RAM has a problem.
Original Misfeed
Original was misfed at following
point.
Open the part as shown, then remove
it.
Output tray has been changed.
Operating Instructions
Description
The LCT (Large Capacity Tray) is
malfunctioning.
The indicated paper input tray is out
of paper.
#: tray number
<xxx>: paper size
<yyy>: paper type
The printer identified a memory
switch (User Account Enhance Unit)
error.
There is a misfeed in the indicated
point.
The output tray has been changed be-
cause the selected output tray cannot
handle the paper size in use.
Maintenance Guide 2 Copier System Edition
Turn the main power switch off and
then on. If the message appears again,
contact your sales or service repre-
sentative.
Reference
Before turning the main pow-
er switch, see "Turning Off
the Main Power" in Adminis-
trator Reference 1.
Load paper into the indicated paper
input tray.
Replace the User Account Enhance
Unit.
Remove the misfed paper.
See p.68 "Removing Misfed
Set the correct output tray.
Solution
Paper".
51