Lanier Copier System Edition Operating Instructions Manual page 442

SLP
Use this command to configure SLP settings.
You can search the NetWare server using SLP in the PureIP environment of NetWare5. To use the slp
command, you can configure the value of TTL which can be used by SLP multi-cast-packet.
Note
The default value of TTL is "1". A search is executed only within a local segment. If the router does
not support multi-cast, the settings are not available even if the TTL value is increased.
The acceptable TTL value is 1 - 255.
msh> slp ttl {1 -255}
Changing the password
Use the passwd command to change the remote maintenance password.
Important
Be sure not to forget or lose the password.
Note
The default factory password is "password".
A A A A
Type "passwd".
msh> passwd
B B B B
Type the current password.
Old password:
Operating Instructions Administrator Reference 2
213