Lanier Copier System Edition Operating Instructions Manual page 536

C C C C
Press the { { { { #} } } } key.
D D D D
Press [Custom Size].
E E E E
Enter the vertical size of the paper
with the number keys, and then
press [#].
Note
❒ The size that you can enter is be-
tween 90 (3.5") to 305mm (12").
❒ To change the number entered,
press [Clear] or the { { { { Clear/Stop} } } }
key and enter the new number.
F F F F
Enter the horizontal size of the
paper with the number keys, and
then press [#].
Note
❒ The size that you can enter is be-
tween 148 (5.8") to 458mm (18").
Copying from the Bypass Tray
❒ If [Horiz. mm] is not highlighted,
press [Horiz. mm].
❒ To change the number entered,
press [Clear] or the { { { { Clear/Stop} } } }
key, and then enter the new
number.
❒ When entering a size over
305mm (12"), the image will be
moved to the center of paper
and copied.
G G G G
To register the custom size en-
tered, press [Program] and then
press [Exit].
Note
❒ If you do not register the cus-
tom size, go to step
❒ Only one custom size can be
stored.
❒ To recall the custom size stored,
press [Recall].
❒ If you do not register the cus-
tom size, the size you set is de-
leted when modes are cleared.
H H H H
Press [OK].
I I I I
Place your originals, and then
press the { { { { Start} } } } key.
1
H
.
35