Lanier Copier System Edition Operating Instructions Manual page 117

Alert Messages
Messages
Add Toner
No toner.
Open the cover as shown and replace
Toner Cartridge by following instruc-
tions shown inside the cover.
Cannot communicate with external
server.
Contact key operator.
Cannot connect with network.
Check settings of IP Address.
Cannot connect with network.
Contact key operator.
Cannot print file stored in PC.
Load paper on #.
Operating Instructions
Description
The indicated toner cartridge(s) is/are
empty.
There is a problem with the Network
settings.
There is a problem with the Network
settings.
There is a problem with the Network
settings.
The paper in tray # ran out while
stored files were being printed.
#: tray number
Maintenance Guide 2 Copier System Edition
Replace the indicated toner car-
tridge(s).
See "Replacing Consumables and
Maintenance Kit" in Maintenance
Guide 1.
Connect the machine to the Network
correctly, and then make sure the
server's power switch is on.
If the message appears again, contact
your key operator, sales or service
representative.
Set a IP address correctly.
See "Configuring the Network with
the Control Panel" in Administrator
Reference 1.
If the message appears again, contact
your sales or service representative.
Connect the machine to the Network
correctly, and confirm other device's
power switch is turned on. If the mes-
sage appears again, contact your sales
or service representative.
Load paper in tray #.
Solution
46