Using An Effect Via Send/Return - Roland M-480 Owner's Manual

Effects and GEQ
2 Applicable effect indication
This indicates the effect to which the FX INSERT/SOURCE
SELECT popup applies.
Insert-destination/input-source select buttons
3
Here you can select the insert-destination channel or the
input-source channel for the effect.
The function buttons have the following operations:
[F1 (CH 1–48 INSERT)] Displays
channel select buttons.
[F2 (BUS INSERT)] Displays AUX1–16,
the insert-destination channel select buttons.
[F3 (AUX OUT)] Displays
select buttons.
[F6 (SELECT NONE)] Clears the input-source selection.
[F8 (CLOSE)] Closes the popup.
Accessing the FX DESTINATION SELECT
popup
1.
Access the EFFECTS screen, and display the FX1–6 tab.
fig.ScrFXOutSelBtn.eps
FX DESTINATION SELECT popup button
2.
Move the cursor to the FX DESTINATION SELECT popup
button L or R of the desired effect, and press [ENTER].
The FX DESTINATION SELECT popup will appear.
fig.ScrFXOutSelGuide.eps
1 2
1 Output channel select buttons
These select the output-destination channel for the effect.
You can select more than one output-destination channel.
100
CH1–48 as the insert-destination
MTX1–8, and MAIN L/R/C
AUX1–16 as the input-source channel
3
2 Applicable effect indication
This indicates the effect to which the FX DESTINATION
SELECT popup applies.
Current output-destination indication
3
This indicates the current output-destination channel.
If more than one output-destination channel are exist, the
lowest number channel is shown.

Using an effect via send/return

as
Effects such as reverb and delay are typically used in a send/
return configuration.
Here we will explain the procedure for using
type effect using AUX15
Specifying the effect input-source
1.
Access the EFFECTS screen, and display FX1–6 tab.
2.
Move the cursor to the FX INSERT/SOURCE SELECT popup
button L for FX5, and press [ENTER].
The FX INSERT/SOURCE SELECT popup will appear.
3.
Press [F3 (AUX OUT)] to access the AUX OUT tab.
4.
Move the cursor to the
to select it.
ig.ScrFXInSel2.eps
5.
Press [F8 (CLOSE)] to close the popup.
6.
In the same way as you did in steps 1 through 5, select
AUX15 as the input-source for the R side of FX5.
FX5 as a send/return
and CH41–42.
AUX15 button, and press [ENTER]