Usb Connector; Lamp Connector; Rs-232C Connector; Digital Out Jack - Roland M-480 Owner's Manual

USB connector

4
fig.USBPortGuide.eps
This USB connector can be connected to your PC to control the
M-480 remotely.
For details, refer to "USB MIDI" (p. 152).

LAMP connector

5
fig.LAMPGuide.eps
This is an XLR-4-31 type connector that supplies power to a
commercially available gooseneck lamp.
fig.PinLamp.eps
NC GND
2 3
NC DC+12V
1
4
MIDI connectors
6
fig.MIDIPortsGuide.eps
These connectors are for connection with MIDI equipment. An IN
connector (for reception) and an OUT/THRU connector (for
transmission and "thru") are provided. You can use the REMOTE
popup to switch between the OUT and THRU functions.
For details, refer to "MIDI settings" (p.
RS-232C / MIDI select switch
7
fig.SerialSelSWGuide.eps
On the M-480 you can use either the MIDI connectors or the RS-
232C connector. This switch selects the connector(s) you will use.
You must switch off the M-480's power before changing the
position of this switch.
[DC+12V/500mA]
153).
Explanation of the panels

RS-232C connector

8
fig.RS232CPortGuide.eps
You can use this RS-232C connector to remotely control the M-
480 from an external device.

DIGITAL OUT jack

9
fig.DigiOutJackGuide.eps
These jacks output a consumer format (IEC-60958 compliant)
digital audio signal. Two types are provided: coaxial and optical.
The same digital audio signal is output from both jacks. By
default, MONITOR L/R is patched to these jacks.

TALKBACK MIC IN jack

10
fig.TBMicGuide.eps
This is a balanced XLR-3-31 female input jack for connecting a
talkback mic.
922
Wiring diagrams for these jacks are shown below. Make
connections after first checking the wiring diagrams of other
equipment you intend to connect.
fig.XLRJackInput.eps
+PHANTOM [+48V/14mA]
HOT GND
COLD

STEREO IN jacks

11
fig.StereoINGuide.eps
These are RCA phono jacks for inputting analog audio signals
from line level equipment. By default they are patched to CH47
and CH48.
31