Roland M-480 Owner's Manual page 190

Management of the M-48 live personal mixer
Saving an M-48 project to USB memory
1.
Access the M-48 LOAD/SAVE popup.
fig.ScrM48LoadSave.eps
2.
In the target unit list, select the M-48 unit whose project
you want to save.
If you want to save the projects for multiple M-48 units, press
[ENTER] to add or clear the check marks in the appropriate
MARK fields.
By pressing [F1 (MARK ALL)] or [F2 (CLEAR MARKS)] you can add
or clear the check marks in all MARK fields of the target unit list.
3.
In the project file list, move to the location in the folder
hierarchy in which you want to save the data.
By selecting a folder and pressing [ENTER], you can move
downward into that folder. By selecting ".." and pressing
[ENTER] you can move back to the folder above the current
one.
Pressing [F3 (MAKE FOLDER)] will create a new folder.
4.
Press [F6 (SAVE)].
fig.ScrM48Save.eps
The M-48 SAVE popup will appear.
If you selected a single M-48 unit in step 2, specify a file name.
If you added a check mark to multiple M-48 units in step 2,
specify a folder name. A new folder with the specified name will
be created, and a separate project file for each M-48 unit will be
saved in that folder. The name of each project file will consist of
the "number in the list" + "unit name."
5.
Edit the name in the name edit field, and press [F8
(SAVE)].
fig.ScrM48Save_Conf.eps
190
A message will ask you to confirm the operation.
The amount of time required for the save procedure to be
carried out will vary depending on the number of M-48 units
you've selected in step 2.
Pressing [F7 (CANCEL)] will cancel the operation.
6.
When you press [F8 (SAVE)], a message indicating the
status of the save procedure will appear.
When saving is finished, the "Completed" message will
appear.
Press [F8 (OK)] to close the message.
Do not disconnect the USB memory or switch off the
power while data is being saved to USB memory. Doing so
may damage the data saved on USB memory.
M-480's