Roland M-480 Owner's Manual page 71

Accessing the GATE/EXPANDER popup
1.
In the fader module section, press a [SEL] button to select
the desired channel.
2.
In the GATE area of the CHANNEL EDIT section, press
[DISP].
fig.PopGate.eps
The GATE/EXPANDER popup will appear.
GATE/EXPANDER popup
fig.PopGateGuide.eps
2 3
1 4
6 8
1 KEY-IN meter
This indicates the level of the key-in signal. For stereo-linked
channels, two meters are shown (L and R).
2 IN meter
This indicates the input level to the gate/expander. For
stereo-linked channels, two meters are shown (L and R).
3 GR (Gain Reduction) meter
This indicates the amount of gain reduction produced by the
gate/expander.
4 Gate/expander graph
This indicates the approximate response of the gate/
expander.
5 OUT meter
This indicates the output level of the gate/expander. For
stereo-linked channels, two meters are shown (L and R).
6 TYPE select button
These select the gate/expander type from the following
choices:
GATE
EXPANDER
DUCKING
7 Parameters
In this field you can edit the gate/expander parameters.
The contents of this field will depend on the type you select
in the TYPE select button.
Dynamics
7
5
9
71