Roland M-480 Owner's Manual page 62

AUX, MTX, MAIN operations
5 MTX SENDS (AUX, MAIN only)
fig.ScrMtxSends.eps
Here you can adjust the sends from the AUX or MAIN to the
MTX.
●
MTX sends 1–8
The MTX send area is structured as follows:
fig.ScrMtxSendField.eps
1 2
3
MTX number
1
This indicates the MTX number.
MTX name
2
This indicates the MTX name.
Send level bar
3
This adjusts the send level to each MTX in a range of -Inf dB–
+10.0 dB.
The color of the level bar indicates the send point or status of
the send switch as follows:
Color of the send Status
level bar
Blue send point is PRE EQ or PRE FADER
Green send point is POST FADER
Gray Send switch is off
●
MTX pan slider
fig.ScrMtxSendField2.eps
If the send-destination is a stereo-linked pair of MTX, this
slider adjusts the left/right position in a range of L63–R63.
This is shown for the odd-numbered MTX send.
For detailed MTX send settings, refer to "p. 85".
62
6 TO MAIN (AUX only)
fig.ScrChMainSend.eps
1
3
4
5
These specify the send level from the AUX to MAIN.
MAIN button
1
This turns the send to MAIN L/R/C. This is shown only when
the LCR button is on.
LR button / C button
2
These individually turn the send to the MAIN L/R and MAIN C
on/off. These are shown only when the LCR button is on.
LCR button
3
This button specifies how signals are sent from the AUX to
MAIN L/R and MAIN C.
OFF The signals sent to MAIN L/R and MAIN C can be
individually turned on/off by using the LR button and C
button.
ON PAN will operate across the three outputs MAIN L,
MAIN C, and MAIN R. The convergence of the sound to
MAIN C can be adjusted by CENTER. The signals sent to
MAIN L/R and MAIN C can be collectively turned on/off
by the MAIN button.
* The MAIN button appears at the position of LR button and C
button when the LCR button is turned on.
CENTER
4
This specifies the proportion of the signal that is sent to
MAIN C when PAN is at C (center) as a value in a range of
0%–100%. This is available when the LCR button is on.
0% No signal will be sent to MAIN C.
100% When PAN is set to C, the signal will be sent only to MAIN
C.
fig.Pan_LCR.eps
Center 0% Center 50%
L C R L
PAN
2
*
Center 100%
C R L C
PAN PAN
R