Setting Up Cascade Connection - Roland M-480 Owner's Manual

Input/output patchbay
Setting up the Cascade Slave console
Output Patchbay settings
1.
Access the PATCHBAY screen.
2.
Press [F2 (OUTPUT)] to access the OUTPUT tab.
fig.ScrPatchOut1608.eps
3.
Press [F4 (REAC B)] to select the REAC B.
4.
Patch the cascade outputs (CAS OUT) to the REAC B
outputs.
Here set as follows:
Cascade output
CAS OUT MAIN L, R, C
CAS OUT AUX1–16
CAS OUT MTX1–8
CAS OUT SOLO L, R
Cascade Link function settings
5.
Press [F8 (CASCADE OPTION)].
fig.ScrCascadeOption_Guide.eps
1
The CASCADE OPTION popup will appear.
CASCADE LINK (REAC) select buttons
1
These buttons specify the function that will be linked by the
Cascade Link function.
Control messages for the checked functions are sent to the
other M-480 via REAC.
When an M-480 receives the control message for the Cascade
Link function, it will be preformed only when the corresponding
function is checked.
• SOLO
This links the solo function. When solo is turned on, the
SOLO bus audio can be monitored from the MONITOR and
PHONES outputs of the Cascade Master console, and the
92
REAC B output
OUT1–3
OUT4–19
OUT20–27
OUT28–29
[SOLO CLEAR] will blink.
To monitoring the Cascade Slave's solo in the Cascade Master
console, you need to cascade connect the SOLO L/R.
• SCENE STORE/RECALL
Storing a scene also stores another M-480's scene into the
same scene number with the same scene name. Recalling a
scene also recalls another M-480's scene with the same
scene number.
The M-480 will not store to a locked scene (p. 120).
The M-480 will not recall a blank scene (p. 120).
Even when the "SCENE STORE" or "SCENE RECALL" item is not
allowed in the User settings (p. 137), the M-480 will follow the
other M-480's storing or recalling commands.
• FADER LAYER/SENDS ON FADER
This links the layer selection in the Layer section, the AUX/
MTX selection in the AUX/MTX SENDS area, and on/off state
of the [SENDS ON FADER] button.
To link the layer selection, press and hold one of the layer
buttons
The [AUX/MTX] layer selection is not linked.
• DCA/MUTE GROUP MASTER
This links the DCA group faders and MUTE group on/off.
The function buttons have the following operations:
[F1 (SEND PARAM)] Sends current parameters to other M-480s.
[F8 (CLOSE)] Closes the popup.
6.
Check desired function for the CASCADE LINK (REAC)
select buttons.
7.
Press [F8 (CLOSE)] to close the popup.