Roland M-480 Owner's Manual page 130

USB memory recorder
If more than one output-destination channel are exist, the
lowest number channel is shown.
The function buttons have the following operations:
[F1 ( )] Selects the previous WAV file.
Holding this down during playback rewinds
the WAV file being played.
[F2 ( )] Selects the next WAV file. Holding this down
during playback fast-forwards the WAV file
being played.
[F3 ( )] Plays the WAV file selected using the song list.
[F4 (REC)] Puts the USB memory recorder into recording
standby.
[F5 (NAME EDIT)] Accesses the NAME EDIT popup, where you can
edit the name of the WAV file (p. 131).
[F6 (DELETE SONG)] Deletes the WAV file that's selected in the song
list (p. 131).
[F7 (PLAY MODE)] Cycles through the available playback modes.
[F8 (PEAK CLEAR)] Clears the level meter's peak hold or over
indication.
Specifying the input-source for the USB
memory recorder
By default, the inputs of the USB memory recorder are specified
as follows:
Input
RECORDER IN L
RECORDER IN R
The RECORDER SOURCE SELECT popup is used to specify the
input.
1.
Access the RECORDER screen.
fig.ScrRecorderPlay.eps
2.
Move the cursor to the L channel of the RECORDER
SOURCE SELECT popup button, and press [ENTER].
130
Input-source
MAIN L
MAIN R
fig.ScrRcdrSrcSelectGuide.eps
1
The RECORDER SOURCE SELECT popup will appear.
1 Current source indication
This indicates the current input-source.
2 Input-source select buttons
Use these to select the input-source channel for the USB
memory recorder.
3.
Move the cursor to the channel that you want to use as
the input-source, and press [ENTER] to select it.
4.
Press [F8 (CLOSE)] to close the popup.
5.
Make settings for the R channel in the same way.
Specifying the output-destination for the
USB memory recorder
By default, the outputs of the USB memory recorder are specified
as follows:
Output
RECORDER OUT L
RECORDER OUT R
The RECORDER DESTINATION SELECT popup is used to specify
the output.
1.
Access the RECORDER screen.
2.
Move the cursor to the L channel of the RECORDER
DESTINATION SELECT popup button, and press [ENTER].
fig.ScrRcdrDestSelectGuide.eps
1
The RECORDER DESTINATION SELECT popup will appear.
2
Output-destination
CH45
CH46
2