Saving/Loading The S-4000M's Input/Output Setups - Roland M-480 Owner's Manual

Saving/Loading the S-4000M's Input/Output Setups

You can save/load the S-4000M input and output setups to a USB
memory as an S-4000M Input/Output Setup file.
To save/load the S-4000M Input/Output Setup File, use the S-
4000M LOAD/SAVE popup.
Accessing the S-4000M LOAD/SAVE
popup
1.
Access the S-4000M CONFIGURATION popup.
fig.S4M_Config1.eps
2.
Press [F4 (LOAD/SAVE)].
fig.S4M_LoadSave_Guide.eps
The S-4000M LOAD/SAVE popup will appear.
File list
1
This lists the S-4000M Input/Output Setup files that have
been saved to USB memory. You can specify the save-
destination folder for the file, or specify the file that you want
to load.
The function buttons have the following operations:
[F1 (LOAD)] Loads the S-4000M Input/Output Setup file
selected in the file list.
[F2 (SAVE)] Saves the S-4000M's input/output setups.
[F3 (MAKE FOLDER)] Creates a folder in the file list.
[F4 (NAME EDIT)] Accesses the NAME EDIT popup where you can
edit the name of the file or folder.
[F5 (DELETE)] Deletes the selected file or folder from the file
list.
[F8 (CLOSE)] Closes the popup
REAC applications and settings
Saving the S-4000M Input/Output Setup
file
1.
Access the S-4000M LOAD/SAVE popup.
2.
Press [F2 (SAVE)].
fig.S4M_Save.eps
The S-4000M SAVE popup will appear.
3.
Edit the name of the S-4000M Input/Output Setup file in
the name edit field.
4.
When you press [F8 (SAVE)], a message indicating the
status of the save procedure will appear. When saving is
completed, the message will close.
Pressing [F7 (CANCEL)] will cancel the operation.
Do not disconnect the USB memory or switch off the
power while data is being saved to USB memory. Doing so
may destroy the data saved in USB memory.
1
Loading the S-4000M Input/Output
Setup file
1.
Access the S-4000M LOAD/SAVE popup.
2.
In the file list, select the S-4000 Input/Output Setup file
that you want to load.
3.
Press [F1 (LOAD)].
fig.S4M_LoadConf.eps
A confirmation message will ask you to confirm the
operation.
4.
When you press [F8 (LOAD)], a message indicating the
status of the load procedure will appear. When loading is
completed, the message will close.
Pressing [F7 (CANCEL)] will cancel the operation.
Do not disconnect the USB memory or switch off the
power while data is being saved to USB memory. Doing so
may destroy the data saved in USB memory.
M-480's
M-480's
151