Roland M-480 Owner's Manual page 218

Live mixing console
Hide thumbs Also See for M-480:
Table of Contents

Advertisement

Appendix
PAN HEAD LONG
Panning of the long playback head
Value:
L63–C–R63
TAPE DIST (Tape Distortion)
Adds distortion typical of a tape
Value:
0–100
WOW and FLUTTER RATE
Speed of pitch modulation caused by tape aging and uneven
rotation
Value:
0–100
WOW and FLUTTER DEPTH
Depth of pitch modulation caused by tape aging and uneven
rotation
Value:
0–100
REVERB
REVERB STEREO Sw (Reverb Stereo Switch)
Specifies whether the reverb sound will be output in stereo
Value:
OFF, ON
REVERB VOL (Reverb Volume)
Level of the reverb sound
Value:
0–100
SBF-325 (STEREO FLANGER SBF-325)
fig.ScrSBF325.eps
This is a stereo-in, stereo-out flanger that models the Roland SBF-
325 Stereo Flanger.
FEEDBACK
Amount of flanger sound returned to the input (valid only if
EFFECT MODE is set to FLANGER)
Value:
0.0–10.0
EFFECT MODE
Value
FLANGER I:
Monaural mode flanger
FLANGER II:
Stereo mode flanger
FLANGER III: Cross-mix mode flanger
OFF:
Modulation off
CHORUS:
Chorus
218
CH-B MOD (CH-B Modulation)
Specifies whether the channel B flanger effect will be inverted
Value:
NORM, INV
CH-A
Specifies whether the channel A flanger sound will be phase-
reversed
Value:
NORM, INV
CH-B
Specifies whether the channel B flanger sound will be phase-
reversed
Value:
NORM, INV
EFFECT Sw (Effect Switch)
Specifies whether the effect sound will be output
Value:
OFF, ON
DIRECT Sw (Direct Switch)
Specifies whether the original sound will be output
Value:
OFF, ON
LEVEL
Output level
Value:
0–100
SPH-323 (PHASE SHIFTER SPH-323)
fig.ScrSPH323.eps
This is a phase shifter that models the Roland SPH-323 Phase
Shifter. The original was mono-in, mono-out, but this modeling is
a dual-mono design with two units in parallel. The MOD LINK Sw
allows you to use this as a stereo-in, stereo-out effect.
CENTER FREQ (Center Frequency)
Center frequency at which the phaser effect is applied
Value:
0–100
RESONANCE
Boosts the region around the center frequency specified by
CENTER FREQ
Value:
0.0–10.0
SHIFT MODE
Specifies the number of stages for the phaser
Value:
8STAGE, 4STAGE

Advertisement

Table of Contents
loading

Table of Contents