Roland Vintage Effects; Digital Reverb Srv - Roland M-480 Owner's Manual

Roland vintage effects

SRV-2000

(DIGITAL REVERB SRV-2000)

fig.ScrSRV2000.eps
This is a mono-in, stereo-out reverb that models the Roland SRV-
2000 MIDI digital reverb. It provides two modes: REVERB mode in
which it operates as a conventional reverb, and NON LNR (non-
linear) mode in which the reverb sound is cut off according to the
gate time setting.
MIX BALANCE
Balance between the direct sound and reverb sound
Value: 0–100
REVERB
MODE
Switches between REVERB mode and NON LNR mode
Value: REVERB, NON LNR
PRE DELAY
Time until the reverb sound is output
Value: 0–160 ms (REVERB mode)
0–120 ms (NON LNR mode)
REV TIME (Reverb Time)
Length of the reverb sound
Value: 0.1–99 s (REVERB mode)
-.9–99 s (NON LNR mode)
The lower and upper limits of the value will differ depending on
the REV SEL setting (in REVERB mode).
REV SEL
P-A, P-B, H37, R37
H32, R32
H26, R26
H22, R22
H15, R15
R7.0
R1.0
R0.3
REV TIME
Lower limit Upper limit
0.5 99
0.4 90
0.3 70
0.2 50
0.1 30
0.1 6.0
0.1 1.0
0.1 0.5
For negative (-) values, the reverberation will gradually become
louder (negative values are shown as -.9, for example).
HF DAMP (Hi Frequency Damp)
Proportion by which the high-frequency range is attenuated
(only in REVERB mode)
Value: 0.05–1.00
GATE TIME
Time from when the reverb sound begins until the sound is cut
off (only in NON LNR mode)
Value: 10–450 ms
REV SEL (Reverb Select)
Type of reverb (only in REVERB mode)
Value
P-A, P-B: Two types of PLATE reverb, A or B
H37, H32, H26, H22, H15:
HALL reverb
Number indicates the room size (in meters)
R37, R32, R26, R22, R15, R7.0, R1.0, R0.3:
ROOM reverb
Number indicates the room size (in meters)
OUTPUT
Output level of reverb sound
Value: 0–99
EQ
HI Q
Steepness of the HI EQ frequency response curve
Value: 0.2–9.0
HI FREQUENCY
Center frequency for the HI EQ
Value: 0.80–9.99 kHz
HI BOOST/CUT
Amount of boost/cut for the HI EQ
Value: -24– +12 dB
MID Q
Steepness of the MID EQ frequency response curve
Value: 0.2–9.0
MID FREQUENCY
Center frequency for the MID EQ
Value: 0.25–9.99 kHz
MID BOOST/CUT
Amount of boost/cut for the MID EQ
Value: -24– +12 dB
Appendix
215