Table of Contents
Advertisement
PAN / AUX / USB / REVERB SEND screen
<PAN>
Adjusts the stereo position (pan).
If you're using two mics to stream a performance, panning the two
mics to left and right will give the sound a more spacious feel.
<REVERB>
Adjusts the amount of audio that is sent to reverb.
<USB SEND>
Sets whether the audio signal is sent to the USB bus. When this is on
(lit), audio is sent to the USB bus.
<AUX>
Adjusts the amount of audio sent to the AUX bus.
AUX <Pre/Post>
Specifies the position from which the audio sent to the AUX bus is
taken.
The send volume is constant, regardless of the input
(PRE)
volume (pre-fader).
The send volume can be changed by adjusting the
(POST)
input volume (pre-fader).
Adjusting the input gain (sensitivity)
Here's how to adjust the input gain so that the audio is at the
appropriate level.
In this example, we use the audio from MIC 1.
1.
On the audio mixer screen, set the MIC 1 and MAIN
volume knobs near the indicator (97 = 0 dB).
¹ Operations using the panel controls
[MIC 1]–[MIC 4] faders
Adjusts the volume of MIC 1–4.
Adjusts the volume of the audio source
INPUT [5] [6] knobs
that's assigned to the knobs.
[MAIN] fader
Adjusts the MAIN volume.
2.
Touch MIC 1 <SETUP>.
The Audio Input Setup screen appears.
3.
Touch <GAIN (dB)> to adjust the input gain while
outputting audio.
Raise the input gain as high as possible without allowing the level
meter to light red when the loudest sound level occurs.
Audio operations
Indicator
21
Advertisement
Table of Contents
