Linking Scene Memories To M-48 Memories - Roland M-480 Owner's Manual

Scene memory
The parameter recall scope buttons correspond to the
following parameters:
• For CH1–48 and RTN 1–6
Item Explanation
Preamp Preamp gain, pad, and +48V phantom power
Phase Phase
ATT Attenuator
HPF* High-pass filter
Gate* Gate/Expander
Comp* Compressor
Delay Delay
EQ* 4-band EQ
Fader Faders
Pan Pan
LCR LCR button, CENTER
Send AUX/MTX sends
Direct Direct out point
Mute Mute
To MAIN MAIN send
*: CH 1–48 only.
• For AUX/MTX/MAIN
Item Setting
ATT Attenuator
EQ 4-band EQ
Fader Faders
Balance Balance
LCR LCR button, CENTER
Phase
Phase
Limiter Limiter
Delay Delay
MTX Send MTX sends
Mute Mute
To MAIN MAIN send
2 Channel recall scope buttons
These buttons specify the channels that will be included in
the recall scope.

Linking scene memories to M-48 memories

Linking M-48 store operations
If desired, M-48 memories can be stored simultaneously when a
scene memory is stored on the M-480.
The current memory of each M-48 unit will be stored to the
specified memory number (except for M-48 units whose
MEMORY SAFE function (p. 175) is on).
Scenes stored by this operation are set so that when they are
recalled, the memories of the M-48 units will also be recalled.
1.
Access the SCENE screen.
126
De-select the channels that you don't want to be recalled.
OTHER parameter recall scope buttons
3
Use these to specify other parameters that will be included
in the scope of recall.
De-select the parameters that you don't want to be recalled.
The function buttons have the following operations:
[F1 (CH 1–48)] Displays
buttons.
[F2 (RTN 1–6)] Displays RTN 1–6 as the channel recall scope
buttons.
[F3 (AUX/MTX/MAIN)] Displays AUX1–16, MTX1–8, and MAIN L/R/C as
the channel recall scope buttons.
[F4 (OTHER)] Displays the OTHER parameter recall scope
buttons.
[F8 (CLOSE)] Closes the popup.
Using the Global Scope function
1.
Access the SCENE screen.
2.
Press [F6 (GLOBAL SCOPE)] to access the GLOBAL SCOPE
popup.
3.
Use the channel recall scope buttons of [F1 (CH 1–48)]
and [F2 (RTN 1–6)] to specify the channel recall scope.
4.
Specify the scope of parameters that will be recalled for
CH 1–48 and RTN 1–6.
5.
Use the channel recall scope buttons of
MAIN)] to specify the channel recall scope.
6.
Specify the scope of parameters that will be recalled for
AUX, MTX and MAIN.
7.
Use the OTHER parameter recall scope buttons of
(OTHER)] to specify the other parameters that will be
recalled.
8.
Press [F8 (CLOSE)] to close the popup.
2.
Select the scene number to use as the destination for the
store operation, and press [F2 (STORE)].
fig.ScrSceneStore2.eps
The SCENE STORE popup will appear.
3.
Verify the scene name shown in the name edit field, and
edit it if desired.
The M-48 memory will be stored with the same name.
CH1–48 as the channel recall scope
[F3 (AUX/MTX/
[F4