Checking And Adjusting The Musician's Mix (Group Mix) - Roland M-480 Owner's Manual

Management of the M-48 live personal mixer
Setting the source assignments
1.
Access the M-48 SOURCE ASSIGN popup.
fig.ScrM48SrcAssign.eps
2.
In the assignment grid, move the cursor to the location
where the desired source and group intersect, and press
[ENTER] to make an assignment symbol appear.
A source can be assigned only to one group. You cannot assign
the same source to multiple groups.

Checking and adjusting the musician's mix (Group Mix)

Accessing the M-48 GROUP MIX popup
1.
Access the desired M-48 SETUP popup.
fig.ScrM48Setup.eps
2.
Press [F5 (GROUP MIX)].
fig.ScrM48GrpMix1_Guide.eps
The M-48 GROUP MIX popup will appear.
182
Clearing the source assignments
1.
Access the M-48 SOURCE ASSIGN popup.
2.
Press [F7 (CLEAR ALL)].
fig.ScrM48SrcAssignClr_Conf.eps
A message will ask you to confirm the operation.
3.
Press [F8 (CLEAR)]; the source assignments will be
cleared and the popup will close.
Pressing [F7 (CANCEL)] will cancel the operation.
1 Target M-48 indication
This indicates the unit name of the M-48 that is the target of
the M-48 GROUP MIX popup.
2 Group mix
fig.ScrM48GrpMix1_Elm1_Gude.eps
Group number
1
1
This indicates the group number.
NAME
2
2
This indicates the group name.
You can move the cursor here and press [ENTER] to access the
NAME EDIT popup.
SOLO button
3
This turns solo on/off for each group.
1
2
3
4
5
6
7