Roland M-480 Owner's Manual page 160

Other settings and functions
Saving mixer settings to USB memory
1.
Access the LOAD/SAVE popup.
fig.ScrSysLoadSave.eps
2.
Move the cursor to the project file list, and move to the
location in the folder hierarchy in which you want to save
the data.
3.
Press [F2 (SAVE)].
fig.ScrSaveProj.eps
The PROJECT SAVE popup will appear.
4.
Use the name edit field to edit the name of the project
files.
For details on name editing, refer to "Editing a name" (p. 39).
5.
Press [F8 (SAVE)] to execute the Save; a "now processing"
message will indicate the progress of the operation.
When saving is completed, the progress indication will
close.
Pressing [F7 (CANCEL)] will cancel the operation.
Do not disconnect the USB memory or switch off the
power while data is being saved to USB memory. Doing so
may destroy the data saved in USB memory.
It's a good idea to save your mixer settings, since in the
unlikely event that the M-480
allow you to move your settings to a backup
continue operating.
160
M-480's
should malfunction, this will
M-480 unit and
Loading mixer settings from USB memory
1.
Access the LOAD/SAVE popup.
fig.ScrSysLoadSave.eps
2.
Move the cursor to the project file list, and select the file
that you want to load.
3.
Move the cursor to the LOAD SECTION select buttons,
and select the sections that you want to load.
4.
Press [F1 (LOAD)].
fig.ScrLoadConf.eps
A message will ask you to confirm the operation.
5.
Press [F8 (LOAD)] to execute the Load; a "now
processing" message will indicate the progress of the
operation. When loading is completed, the progress
indication will close.
Pressing [F7 (CANCEL)] will cancel the operation.
Do not disconnect the USB memory or switch off the M-480's
power while data is being loaded from USB memory. Doing
so may destroy the data saved in USB memory.
If you attempt to load mixer settings when a locked scene or
library exists, the following caution message will appear.
fig.ScrProjLockedCaut.eps
If you press [F7 (CANCEL)], the operation will be cancelled.
If you press [F8 (LOAD)], the mixer settings will be loaded
(the locked data will be overwritten).