Roland M-480 Owner's Manual page 24

Explanation of the panels
EQUALIZER area
7
fig.ChEdtEQ.eps
In this area you can operate the 4-band EQ that is provided on
CH1–48, AUX1–16, MTX 1–8, and MAIN L/R/C.
• [ON] button
This button turns the EQ on/off. It will light if the EQ is on.
• [DISP] button
This accesses the EQUALIZER popup where you can make
detailed settings. The button will light red when the popup
is shown.
• Q knob
This adjusts the Q of each band.
• FREQ knob
This adjusts the frequency of each band.
• GAIN knob
This adjusts the gain of each band.
When the GATE/EXPANDER popup (p. 71), COMPRESSOR popup
(p. 76), or LIMITER popup (p. 80) is displayed, the parameters of
the gate/expander, compressor, or limiter can be adjusted using
the Q knobs, FREQ knobs, or GAIN knobs.
PAN area
8
fig.ChEdtPan.eps
• PAN knob
For CH 1–48 and RTN 1L–6R,
16, MTX 1–8, MAIN L/R, it adjusts the balance.
24
this adjusts the pan. For AUX 1–
AUX/MTX SENDS area
8
fig.ChEdtAux.eps
In this area you can adjust the send level to the AUX/MTX buses.
• [AUX1]–[AUX16] buttons
These buttons select the send-destination bus. AUX or MTX
can be selected on CH and RTN, MTX can be selected on AUX
and MAIN.
To select an MTX as the send-destination, hold down one of the
[AUX1]–[AUX8], and press its right side [AUX9]–[AUX16].
You can turn the corresponding send switch on/off by holding
down [SHIFT] and pressing [AUX1]–[AUX16].
• [DISP] button
This button accesses the AUX (MTX) SENDS popup. It will
light red when the popup is shown.
• LEVEL knob
This adjusts the send level to the selected AUX/MTX bus.
If a MTX channel is selected, this will adjust the send levels from
AUX1–16 to MTX.
If AUX/MTX buses are stereo-linked, selecting the odd-
numbered AUX/MTX bus will let you adjust the send pan, and
selecting the even-numbered AUX/MTX bus will let you adjust
the send level.
• [SENDS ON FADER] button
This button turns SENDS ON FADER mode on/off. It will blink
if SENDS ON FADER mode is on.
"Using the SENDS ON FADER" (p. 45)