Motion Detector Test - Bosch IUI?MAP0001?2 User Manual

28 en | Operation
P
How to resume a walk test
A first walk test has been interrupted.
The user logged off the control panel before a walk test was completed.
4
P
How to execute a seismic test
All areas of the system are disarmed.
1.
2.
3.
4.
P
How to print a walk test
A first walk test has been completed.
The system printer is connected and ready to print.
1.
2.
P
5.8.6

Motion detector test

The motion detector test function enables the LED on motion detectors to flash, whenever
movement is detected.
How to open the Service menu
4
P
How to start the motion detector test
1.
2.
3.
2019-11 | 08 | F.01U.168.328
The walk test is finished.
Press Resume Walk Test.
A message is displayed, stating that event communication will be disabled during the
walk test.
The walk test is resumed.
Press Start Seismic Test.
A message is displayed, stating that event communication will be disabled during the
seismic test.
The last point (device) tested and a list with untested points is displayed.
Optional: To toggle between displaying a list of untested and already tested points, press
the icon.
Trigger all seismic devices that are part of the seismic test. Seismic detectors equipped
with a test transmitter are tested automatically. Seismic detectors that do not have a test
transmitter must be triggered manually.
Triggered devices move from the list of untested points to the list of tested points.
Optional: To print the seismic test, press the
How to print a walk test, page 28.
The seismic test is finished.
Press Print Walk Test.
Choose between Print Tested Points and Print Untested Points.
The walk test with the selected option is printed on the system printer.
To open the Service menu, press
The Service menu with twelve menu options is displayed.
Press Motion Detector Test.
The motion detector test options are displayed.
To enable or disable the motion detector test for all motion detectors, press Motion Test
All Areas.
To enable or disable the motion detector test for all motion detectors in a specific area,
press Motion Test Selected Area.
The icon indicates that the motion detector test is enabled. The
that the motion detector test is disabled.
To trigger a motion detector, move in front of it.
icon. For more information, refer to
and .
User manual
MAP Control Center
icon indicates
Bosch Security Systems B.V.