Change Name; Detector Sensitivity; Operator - Bosch FPA‑5000 User Manual

FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
2.
3.
4.
Refer to
–
18.3.2

Change name

To change the name of the input or output group:
1.
2.
18.4

Detector sensitivity

Caution!
Detector sensitivity is automatically reset to the default setting
!
When the entire panel or the individual detector/logical zone is reset
When the detector is replaced
Two different sensitivities can be assigned to detectors and logical zones in the FSP-5000-RPS
programming software — a default setting and an alternative setting.
It is possible to switch between the default and alternative setting on the panel controller.
To change the setting:
1.
2.
3.
4.
5.
18.5

Operator

Depending on whether the same password is used per access level, or whether each user has
a different password, one of the following two options is offered:
If the same password is used per access level:
–
If each user uses a different password:
–
–
Bosch Sicherheitssysteme GmbH
Select the element category you require.
Select one or more list fields.
The list fields are marked.
Select Add.
The selected element is added to the selected walktest group.
Scrolling through lists, page 25
Overwrite the name
Select OK.
The new name is confirmed.
In the start menu, select Configuration
Detector sensitivity
Various lists are offered. Select one of the detector or logical zone lists that are offered.
A list of elements is displayed. Depending on the list you have selected, enter the number
or the name of the element into the search screen.
Select the list field you require, e.g. a logical zone in this case.
Two settings are displayed: There is a checkmark in the selection field in front of the
active setting.
Select the selection field of the detector sensitivity you require.
A checkmark is set in this field.
Select OK to confirm the selection or Cancel to cancel the operation.
The selected detector sensitivity is confirmed for the detector.
Change universal password: The same password can be configured for each access level
in the FSP-5000-RPS programming software. This means that all operators with access
authorization for the second level receive the same password, for example. The password
for access levels two to four can be changed.
Change operator data: Change the password for an operator.
Set default password: Reset a user password to the following number sequence: 000000.
User Guide
Configuration | en 77
2020-07 | 3.0 | F.01U.378.877