Serial Interface; Can-Bus; Panel Passport; Led Test On Modules - Bosch MPC-xxxx-C Series User Manual

64 en | Diagnostics
4.
5.
14.4.3

Serial Interface

Select Serial interface to display the statistical data for the transmission.
14.4.4

CAN-Bus

Select CAN bus to display the status of the CAN interfaces.
14.5

Panel Passport

Select Panel passport to display the following diagnostic information:
–
–
–
–
–
–
–
–
–
–
–
14.6

LED Test on modules

To test the LED display of selected modules:
1.
2.
A list of various selection criteria is offered:
–
–
Example
To test the LED displays of an LSN 300 module:
1.
2.
3.
4.
Notice!
The numbers before the module names indicate the slot of the module on the panel.
14.7

Network services

14.7.1

Routing table

To display routing information:
2017.09 | 7.0 | F.01U.258.929
Adjust touch screen
Carry out the steps shown on the display.
Module
Address
CAN ID
Production date
BOM revision
PCBA material number
Material number
Software version
Build type
Build number
MAC Addresses
In the start menu, select Diagnostics
LED test on modules
Select LED test all modules to test the LED display of all modules.
Select By number or By type to test the LED display of individual selected modules.
Select By type.
A list of all module types is displayed.
Select the LSN 300 module.
A list of all LSN 300 modules is displayed.
Select the list field(s) you require. The list fields are marked.
Select Activate LEDs.
The LEDs are activated for the duration of approx. five seconds.
User Guide
Panel Controller
Bosch Sicherheitssysteme GmbH