User Code Functions; Fault Analysis Mode; Hold Down Functions - Bosch Solution 6+6 Quick Reference Manual

Page 10

User Code Functions

Description
Function
0 Arming or Disarming Both Areas At The Same Time (Partitioning Only)

Fault Analysis Mode

There are various system faults that can be detected by the control panel. When any of these are present the
FAULT indicator will begin to flash and the codepad will beep once every minute. Hold the
two seconds until two beeps are heard. The STAY and AWAY indicators will begin to flash in unison with the
FAULT indicator. One or more zone indicators (1-8) will illuminate to indicate the current fault(s). Refer to the
following table below.
Zone
Indicator

Hold Down Functions

Hold down functions have been incorporated to allow easy activation of specific operations. When a button is
held down for two seconds, two beeps will be heard and a particular function will operate. The hold down
functions are listed below.
Function
AWAY Arm The System In AWAY Mode
STAY Arm The System In STAY Mode
0 Reserved
1 Horn Speaker Test
Bell Test
2
Strobe Test
3
Turning Day Alarm On and Off
4
5 Fault Analysis Mode
6 Initiate Modem Call
7 Reset Latching Outputs
8 Codepad ID Beeper Tone Change
9 Initiate Test Report
SOL 6+6 QUICK REF GUIDE.DOC
Table 7: User Code Functions
Low Battery
1
2 Date and Time
3 Sensor Watch
4 Horn Speaker Disconnected
5 Reserved
2
6 E Fault
7 Reserved
8 Communications Failure
Table 8: Fault Types
Table 9: Hold Down Functions
Bosch Security Systems Pty Limited
Solution 6+6
Description
Description
Quick Reference Guide
5
button down for