Cutter Mode - SATO GY412 Operator's Manual

Section 8: Appendix
8.1 CUTTER AND PRINTER MOTION (cont'd)
8.1.4.2 Tear-off Mode
The base position for printing and manual cutting in tear-off mode is shown below.
I-mark
I-mark
For the I-mark sensor, the top of label is the base position for tear-off.
For the GAP sensor, 1.5mm before the base position for printing is the tear-off position.

8.1.4.3 Cutter Mode

The base position for printing and cutting in cutter mode is shown below.
I-mark
For the I-mark sensor, the top of label is the base position for cutting.
For the GAP sensor, 1.5mm before the base position for printing is the cutting position.
Page 8-6
Base position for
Base position for
tear-off
tear-off
Base position for
Base position for
printing
printing
Base position for
cutting
Base position for
printing
GAP
GAP
Base position for
Base position for
tear-off
tear-off
Base position for
Base position for
printing
printing
1.5mm
1.5mm
GAP
1.5mm Base position for
cutting
Base position for
printing
GY412 Operator Manual