SATO GY412 Operator's Manual page 114

Section 3: Operation and Configuration
3.3 LCD MESSAGE DETAILS (cont'd)
Display
Onscreen
message
Operation
button
Display
Onscreen
message
Operation
button
Page 3-86
Service Mode - Slice level of I-mark sensor
SENSOR LEVEL
I-MARK SLICE LEVEL
0.0V
Button
↓, ↑
ENTER
CANCEL
FUNCTION
Service Mode - Slice level of Gap1 sensor
SENSOR LEVEL
GAP1 SLICE LEVEL
0.0V
Button
↓, ↑
ENTER
CANCEL
FUNCTION
Displaying current I-mark sensor level and auto-
matically calculated slice level.
Use ↑ and ↓ keys to enter slice level and press
ENTER.
The setting range is from 0.0 to 3.2, set by 0.1V.
Firmware will set the slice level automatically if
setting the slice level to "0.0".
Description
Enters slice level value by 0.1.
Saves the setting and goes to the [SENSOR
LEVEL GAP1] screen.
Goes to the [SERVICE MODE] screen without
saving the setting.
Goes to the [SERVICE MODE] screen without
saving the setting.
Displaying current GAP1 (center hole) sensor
level and automatically calculated slice level.
Use ↑ and ↓ keys to enter slice level and press
ENTER.
The setting range is from 0.0 to 3.2, set by 0.1V.
Firmware will set the slice level automatically if
setting the slice level to "0.0".
Description
Enters slice level value by 0.1.
Saves the setting and goes to the [SERVICE
MODE] screen.
Goes to the [SENSOR LEVEL I-MARK] screen
without saving the setting.
Goes to the [SERVICE MODE] screen without
saving the setting.
GY412 Operator Manual