SATO GY412 Operator's Manual page 209

8.10 PRINT OPERATION SEQUENCE (cont'd)
8.10.5 Cutter Mode (Head check disabled)
(1) Motion
Standby
The upper head is up.
The lower head is down.
Backfeed motion starts.
Backfeed to pitch
sensor position
The upper head is down.
The lower head is up.
Start feeding the label and
printing from the lower surface
of the first label.
The lower surface of the first
label is printed. When the
second label is fed while
printing the upper surface of
the first label, the print on the
lower surface of the second
label will not start.
After finishing double sided print of
the first label, the label is fed to cut
position.
Label cut
When the next data is ready;
The upper head is up.
The lower head is down.
Backfeed motion starts.
Position adjustment at the top
of the second label.
Notes:
• The above is the base position when the I-mark sensor is selected.
GY412 Operator Manual
Label feed direction
Cut position Upper head Lower head Pitch sensor
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Section 8: Appendix
Page 8-27