SATO GY412 Operator's Manual page 107

3.3 LCD MESSAGE DETAILS (cont'd)
Display
Onscreen
message
Operation
button
Display
Onscreen
message
Operation
button
GY412 Operator Manual
Test Print Mode - Adjustment of print position on the lower surface
PITCH POSITION LOWER
+0.00
ENTER -> PRINT
Button
↓, ↑
←, →
ENTER
CANCEL
FUNCTION
Test Print Mode - Adjustment of offset position
OFFSET POSITION
+0.00 mm
ENTER -> PRINT
Button
↓, ↑
←, →
ENTER
CANCEL
FUNCTION
Section 3: Operation and Configuration
Adjusting the print position on the lower surface.
Use ↑ and ↓ keys to change setting value and
press ENTER to start test print.
The setting value can be adjusted by ±0.25mm
regardless of print density.
The setting range is ±3.75mm and the default set-
ting is "+0.00"mm.
Description
Enters setting value by ±0.25mm.
Toggles the screens.
Starts test print.
Goes to the [TEST PRINT SIZE] screen.
Goes to the [TEST PRINT MODE] screen.
Adjusting offset position.
Use ↑ and ↓ keys to change setting value and
press ENTER to start test print.
The setting value can be adjusted by ±0.25mm
regardless of print density.
The setting range is ±3.75mm and the default set-
ting is "+0.00"mm.
Description
Enters setting value by ±0.25mm.
Toggles the screens.
Starts test print.
Goes to the [TEST PRINT SIZE] screen.
Goes to the [TEST PRINT MODE] screen.
Page 3-79