Section 2: Installation
2.3 LOADING LABELS, CONT'D
Warnings
•
When replacing media, bear in mind that the print heads and their surrounding areas remain hot.
Keep your fingers away from these areas to prevent injury.
•
Avoid touching even the edge of the print head with your bare hands.
1.
Switch on power.
2.
Position stack of fanfolded label media to the rear of the printer.
3.
Insert the leading edge of the fanfolded label media in the label feed entrance at the top rear of the printer.
The printer will automatically feed it. Depending on the sensor type to be used, when you turn on the
power, the top of the label or I-mark will be detected and then, the printer will feed the label to the standby
position.
Page 2-4
Figure 2-1, Inserting the media
GY412 Operator Manual