Auto Label Feed - SATO GY412 Operator's Manual

8.4 AUTO LABEL FEED

When the printer runs out of label completely, the thermal head and the roller will be lifted up for loading the
label from the rear side of the printer.
After loading the label, close the platen and adjust the label position.
Depending on the sensor type to be used, the top of label or I-mark will be detected and then, the label will be
fed to the standby position. Label feed speed for auto paper feed is fixed at 3 inch/sec.
No label
Load the label, close the
platen and adjust the label
position
Feed the label backward to the
pitch sensor position and detect
the top of label or I-mark
Feed the label to the standby
position and complete the auto
label
Note:
• The above is the base position when the I-mark sensor is selected.
GY412 Operator Manual
Upper head Lower head
Section 8: Appendix
Pitch sensor
Up
Down
Up
Down
Up
Down
Up
Down
Page 8-11