SATO GY412 Operator's Manual page 156

Section 6: Basic Specifications
6.1 PRINTER BASIC SPECIFICATIONS (cont'd)
MEDIA
(Be sure to use media manufactured or certified by SATO)
Paper Setting Position
Paper Thickness
Size
Type
LABEL ISSUING MODES
COMMAND
SBPL
SEMBL
Page 6-6
Center position
Label: 100 to 320 μm
Label: 0.003 to 0.012 in. (0.1 to 0.32 mm)
Continu- Label
ous mode
Tear-off Label
mode
Cutter
Label
mode
Label
Label
cutting
during
print
operation
Standard: Continuous mode, Tear -off mode, Cutter mode, and Label Cutting During
Pitch: 1.18 to 11.81 in.(Backing liner 1.29 to 11.9 in.)
Width: 1.96 to 5.15 in. (Backing liner 2.04 to 5.19 in.)
Pitch: 30 to 300 mm (Backing liner 33 to 303 mm)
Width: 49 to 129 mm (Backing liner 52 to 132 mm)
Pitch: 1.18 to 11.81" (Backing liner 1.29 to 11.9")
Width: 1.96 to 5.15 in. (Backing liner 2.04 to 5.19 in.)
Pitch: 30 to 300 mm (Backing liner 33 to 303 mm)
Width: 49 to 129 mm (Backing liner 52 to 132 mm)
Pitch: 1.18 to 11.81" (Backing liner 1.29 to 11.9")
Width: 1.96 to 5.15 in. (Backing liner 2.04 to 5.19 in.)
Pitch: 30 to 300 mm (Backing liner 33 to 303 mm)
Width: 49 to 129 mm (Backing liner 52 to 132 mm)
Pitch: 1.18 to 11.81" (Backing liner 1.29 to 11.9")
Width: 1.96 to 5.15 in. (Backing liner 2.04 to 5.19 in.)
Pitch: 30 to 300 mm (Backing liner 33 to 303 mm)
Width: 49 to 129 mm (Backing liner 52 to 132 mm)
*Note: The size may be limited by use conditions.
Direct Thermal fanfold
Print Operation mode
Version 4.6 or higher
Version 1.0 or higher
GY412 Operator Manual