Reverse Eject Motion - SATO GY412 Operator's Manual

Section 8: Appendix

8.6 REVERSE EJECT MOTION

The GY412 printer has the reverse eject function to achieve better operability. Pressing the [↑] key in
OFFLINE state will execute the reverse eject motion.
The head assembly will be lifted up and the label will be fed backward in the reverse eject motion. When the
label is off the platen completely, "no label error" will occur and the printer stops.
Notes:
• If a sensor malfunction occurs during the reverse eject motion or if the printer cannot detect the top of
label, the printer will feed the label for 650mm and generate a sensor error.
Standby
Start of reverse eject motion
Close the lower head
Feed the label backward
No label error occurs because the label
is not at the sensor position.
In this case, the platen is lifted up for
loading the label.
Page 8-14
Upper head Lower head
Paper end sensor
Up
Down
Up
Down
Up
Down
Up
Down
GY412 Operator Manual