SATO GY412 Operator's Manual page 211

8.10 PRINT OPERATION SEQUENCE (cont'd)
8.10.6 Cutter Mode (Head check enabled)
(1) Motion
Standby
The upper head is up.
The lower head is down.
Backfeed motion starts.
Backfeed to pitch
sensor position.
The upper head is down.
The lower head is up.
Start feeding the label and
printing from the lower surface
of the first label.
The lower surface of the first
label is printed. When the
second label is fed while
printing the upper surface of
the first label, the print on the
lower surface of the second
label will not start.
After finishing double sided print of
the first label, the label is fed to cut
position.
Label cut
Head check after label cut.
Note:
• The above is the base position when the I-mark sensor is selected.
GY412 Operator Manual
Label feed direction
Cut position Upper head
Head check
Lower head Pitch sensor
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Up
Down
Section 8: Appendix
Page 8-29