SATO GY412 Operator's Manual page 153

6.1 PRINTER BASIC SPECIFICATIONS (cont'd)
I-MARK SENSOR POSITION
GY412 Operator Manual
0.12 in.
0.04 in.
(3.0 mm)
(1.0 mm)
0.39 in (10.0 mm) or more
0.12 in
(3.0 mm)
No pre-print is advised in the feed path of the I-mark.
Section 6: Basic Specifications
As seen from back side
Perforation
The best position
to cut is at a little
bit below the
perforation
Page 6-3