Communication Settings - SATO GY412 Operator's Manual

Section 7: Interface Specifications
7.3 RS-232C SERIAL INTERFACE (cont'd)

Communication settings

The following items can be set through the interface mode of the printer.
Item
Protocol
Baud rate
Data bit strength
Parity bit
Stop bit
* Ready/Busy and XON/XOFF are not supported in [Protocol].
Synchro system
Maximum receive
buffer capacity
Code
Signal level
Reception method
Page 7-4
STATUS3
STATUS4 (Protocol for the driver) (* Default value)
STATUS5
2400bps, 4800bps
9600bps, 19200bps(* Default value)
38400bps, 57600bps
7 bits, 8 bits (* Default value)
NONE (* Default value), ODD, EVEN
1 bit (* Default value), 2 bits
Asynchronous method
2.95 MB
0 MB
Near full occurred
Near full released
ASCII (7 bits), Graphic (8 bits)
High level : +5V to ~+12V
Low level : -5V to ~+12V
Multi buffer *Single item buffer is not supported.
Setting Range
Remaining 0.95 MB
Remaining 1.95 MB
GY412 Operator Manual
2.95 MB