SATO GY412 Operator's Manual page 63

3.3 LCD MESSAGE DETAILS (cont'd)
Display
Onscreen
message
Operation
button
GY412 Operator Manual
Normal Mode - Adjustment of base point for printing on the lower surface
PITCH OFFSET
LOWER HEAD
V:+0000 H:+0000
Button
↓, ↑
→, ←
ENTER
CANCEL
FUNCTION
Section 3: Operation and Configuration
This coordinates the base point for printing on the
lower surface.
Use the up and down arrow buttons to change
setting value and press ENTER.
Use the left and right arrow buttons to move the
cursor, and to select an input item.
V is the vertical print position and H is the hori-
zontal print position.
You can set this by 1 dot, and the default setting
is V:+0000 H:+0000, regardless of print density.
Setting range:
V: ±0 to 1200, H: ±0 to 1200.
Description
Enters setting value.
Move the cursor to + and - for its switch over.
Moves the cursor.
Saves the setting, and goes to the CUTTER OFF-
SET screen.
Goes to the PITCH OFFSET UPPER HEAD
screen without saving the setting.
Goes to the ONLINE MODE screen, without sav-
ing the setting.
Page 3-35