Label Saving Function - SATO GY412 Operator's Manual

Section 8: Appendix

8.9 LABEL SAVING FUNCTION

The GY412 printer has a label saving function.
1.
Printing from the top of label
If it is possible to set the sensor type to the label top and to read the label position, the printer will feed the
label automatically and adjust the label position. If having a problem reading the I-mark at the start or the top
of label, the print may not start from the top of label because the label position cannot be set correctly. The
GAP sensor detects the edge of label. The I-mark sensor recognizes the I-mark; therefore, the I-mark and the
label edge must be 2mm or more.
2.
Printing to the end of label
When the label pitch is 40mm or more, the printer will print the data to the end of label in continuous mode and
print-cut mode. Note that this function is invalid in cutter mode.
Page 8-18
GY412 Operator Manual