Attach The Document Table (Multifunction Printer Model Only) - Oki LP-1040 Installation Manual

3.4.9

Attach the document table (Multifunction Printer Model only)

1
Required tools
2
Remove the document table from
the box.
The following seven screws are supplied with the document
table.
- Five hexagon plus socket head TP machine screws
- Two plus socket head machine screws
Chapter 3 Receive the shipment and set up the Printer in the final position
210 mm
(8.27 inches)
3-21
OKI Data Infotech Corporation CONFIDENTIAL
Phillips screwdriver (#2) x1
- Between 150 mm (5.91 inches) and
210 mm (8.27 inches) in length
(180 mm (7.09 inches)
recommended)
-
Two brackets are installed on the document table
(one on each side) when the Printer is supplied.
They are used to keep the document table at the
right angle.
After the document table has been installed, these
brackets should be removed as they are not
required anymore. However, do not dispose of
them as they may be used the next time you move
the Printer.
Magnetic