Connecting The Interfaces And Devices - Cisco UC520-24U-8FXO-K9 Overview

Prerequisites
• Pentium III-based IBM PC or compatible computer with 512 MB DRAM (1 GB DRAM
recommended), minimum screen resolution of 1024x768, and Windows XP (Service Pack 1 or
later) or Windows 2000 (Service Pack 3 or later) installed.
If necessary, install Configuration Assistant on a PC you will use to manage the configuration
Step 1
of the UC 520. For installation information, see the Getting Started with Cisco Configuration
Assistant document at
with the product.
If necessary, use an RJ45-to-RJ45 Ethernet cable to connect the Ethernet port of the PC on
Step 2
which the Configuration Assistant is installed to a PoE port on the front panel of the UC 520
to which this switch is connected.
Step 3 Launch Configuration Assistant. For information, see the Getting Started with Cisco
Configuration Assistant document at
CD-ROM that shipped with the product.
Use Configuration Assistant to perform the following tasks. For information, see online help.
Step 4
a. Verify that the switch you just installed appears on the Topology View page.
b. Add the Cisco Catalyst Express 520 switch to the Community for the UC 520. For more
information, see the online help.
10

Connecting the Interfaces and Devices

This section contains the following topics:
Connect the Interfaces, page 40
•
• Connect the Devices, page 40
These steps are typically performed while deploying the UC 520 at your customer's site.
Note
http://www.cisco.com/go/configassist
http://www.cisco.com/go/configassist
or on the CD-ROM that shipped
or on the
39