Show Poe Port Info - NETGEAR ProSafe GSM7224P User Manual

show poe port info

Use this command to get information about the status of the PoE ports. You can display
information based on each individual port or all the ports collectively. The command displays only
PSE-capable ports.
Format
show poe port info [<port> |all]
Mode Privileged EXEC
User EXEC
Term Definition
Intf Interface on which PoE is configured.
Class Class of the powered device according to the IEEE802.3af and IEEE802.3at definition.
Class Usage Max Power (watts)
0 Default 0.44-12.95
1 Optional 0.44-3.84
2 Optional 3.84-6.49
3 Optional 6.49-12.95
4 Optional 12.95-25.5
Power The power supplied to the powered device (in watts).
Output The current supplied to the powered device (in mA).
Current (mA)
Output The voltage supplied to the powered device (in volts).
Voltage (volts)
Status The Status field reports the state of power supplied to the port. Possible values are:
• Disabled—The PoE function is disabled on this port.
• Searching—The port is detecting the PoE device.
• Delivering Power—The port is providing power to the PoE device.
• Fault—The POE device is not IEEE compliant; no power is provided.
• Test—The port is in testing state.
• Other Fault—The port has experienced problems other than compliance issues.
When a port begins to deliver power, there is a trap indicating so. When a port stops
delivering power, there is a trap indicating so.
Example:
(switch) #show poe port info all
High Max
Intf Power Power
(W)
------ ------- ----- -------
1/0/1 Yes 32.0
(Switch) #show poe port info 1/0/33
High Max
ProSafe Managed Switch
Output
Class Power Current
(W) (mA)
------ -------
Unknown 00.000 0
Output
Power over Ethernet (PoE) Commands
Output
Voltage Status
(volt)
------- ------------------ ---------------
00.00 Searching
Output
499
Fault
Status
No Error