Ip Address Dhcp - NETGEAR ProSafe GSM7224P User Manual

no ip routing
This command disables the IP Router Admin Mode for the master switch.
Format
no ip routing
Mode
Global Config
ip address
This command configures an IP address on an interface. You can also use this command to
configure one or more secondary IP addresses on the interface.The value for <ipaddr> is
the IP address of the interface. The value for <subnetmask> is a 4-digit dotted-decimal
number which represents the subnet mask of the interface. The subnet mask must have
contiguous ones and be no longer than 30 bits, for example 255.255.255.0. This command
adds the label IP address in show ip interface.
Format
ip address <ipaddr> <subnetmask> [secondary]
Mode
Interface Config
no ip address
This command deletes an IP address from an interface. The value for <ipaddr> is the IP
address of the interface in a.b.c.d format where the range for a, b, c, and d is 1-255. The
value for <subnetmask> is a 4-digit dotted-decimal number which represents the Subnet
Mask of the interface. To remove all of the IP addresses (primary and secondary) configured
on the interface, enter the command no ip address.
Format
no ip address [{<ipaddr> <subnetmask> [secondary]}]
Mode
Interface Config

ip address dhcp

Use this command to enable the DHCPv4 client on an in-band interface so that it can acquire
network information, such as the IP address, subnet mask, and default gateway from a
network DHCP server. When DHCP is enabled on the interface, the system automatically
deletes all manually configured IPv4 addresses on the interface.
Default
disabled
Format
ip address dhcp
Mode
Interface Config
ProSafe Managed Switch
Routing Commands
238