Show Ip Ospf Abr; Show Ip Ospf Area - NETGEAR ProSafe GSM7224P User Manual

External LSA Count............................0
External LSA Checksum.........................0
AS_OPAQUE LSA Count...........................0
AS_OPAQUE LSA Checksum........................0
LSAs Originated...............................0
LSAs Received.................................0
LSA Count.....................................0
Maximum Number of LSAs........................18200
LSA High Water Mark...........................0
Retransmit List Entries........................ 9078
Maximum Number of Retransmit Entries........... 72800
Retransmit Entries High Water Mark............. 72849

show ip ospf abr

This command displays the internal OSPF routing table entries to Area Border Routers
(ABR). This command takes no options.
Format
show ip ospf abr
Mode
• Privileged EXEC
• User EXEC
Term Definition
Type
The type of the route to the destination. It can be either:
• intra — Intra-area route
• inter — Inter-area route
Router ID
Router ID of the destination.
Cost
Cost of using this route.
Area ID
The area ID of the area from which this route is learned.
Next Hop
Next hop toward the destination.
Next Hop Intf
The outgoing router interface to use when forwarding traffic to the next hop.

show ip ospf area

This command displays information about the area. The <areaid> identifies the OSPF area
that is being displayed.
Format
show ip ospf area <areaid>
Modes
• Privileged EXEC
• User EXEC
Term Definition
AreaID
The area id of the requested OSPF area.
External
A number representing the external routing capabilities for this area.
Routing
ProSafe Managed Switch
Routing Commands
293