Show Poe Port Info - NETGEAR ProSafe GSM7228PS Cli Manual

show poe port info

This command displays the status for the ports that support the PoE function.You can display
information on a per port basis or all the ports at the same time.
Format
show poe port info {<unit/slot/port>|all}
Mode Privileged EXEC
User EXEC
(GSM7252PS) #show poe port info 1/0/13
High Max
Intf Power Power
(W)
------ ------- -----
1/0/33 No 18.0
Overload Counter .............................. 0
Short Counter ................................. 0
Power Denied Counter .......................... 0
Absent Counter ................................ 0
Invalid Signature Counter ..................... 0
Term Definition
Intf Interface on which PoE is configured.
Class Class of the powered device according to the IEEE802.3af and IEEE802.3at definition.
Class
0
1
2
3
4
Power The power supplied to the powered device (in watts).
Output Current The current supplied to the powered device (in mA).
(mA)
Output Voltage The voltage supplied to the powered device (in volts).
(volts)
Status The Status field reports the state of power supplied to the port. Possible values are:
Disabled — the PoE function is disabled on this port
Searching — the port is detecting PoE device
Delivering Power — the port is providing power to PoE device
Fault — the POE device is not IEEE compliant, no power is provided
Test — the port is in testing state
Other Fault — the port has experienced problems other than compliance issues.
When a port begins to deliver power, there will be a trap indicating so. When a port stops
delivering power, there will be a trap indicating so.
Power Over Ethernet Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
Output Output
Class Power Current
(W)
------- ------ -------
2 04.400
Usage Max Power (watts)
Default 0.44-12.95
Optional 0.44-3.84
Optional 3.84-6.49
Optional 6.49-12.95
Optional 12.95-25.5
v1.0, May 2010
Voltage Status
(mA) (volt)
------- ----------------
84 53.3 Delivering Power
Fault
Status
--------------
No Error
5-11